Electric Vehicle Battery Maintenance 6 Skills

Right now, electric cars because of its advantages such as light pollution deeply consumers, while the mileage to measure the length of a consumer good or bad the quality of electric vehicles, one of the main criteria. It is worth mentioning that a large number of electric vehicles in the quality of complaints, accounting for over 95% of the battery problem, because the battery is to determine the length of electric vehicles an important factor in the exercise of mileage. Then the normal maintenance of electric vehicle batteries should pay attention to what the problem?

“Times can be battery Rehabilitation Center” maintenance of professional knowledge on the battery and gave specific description.

Technique, when a non-loss storage electric

When the battery in storage is prohibited in the state power loss. Loss refers to the battery power status is failure to make timely charge after use. Stored battery power status in the deficit, it is prone to sulfate, lead sulfate crystals attached to the pole plate, plug the electric ion channels, resulting in insufficient charging, the compaq Presario R3000 battery capacity decline. Idle state electricity loss the longer the more serious the damage to the battery. Therefore, the battery idle, we should add power once a month, so that can better maintain battery health.

2 regular inspection techniques

The use of process, if continued line of electric cars, a sudden drop in mileage in a short time more than ten kilometers, it is likely that at least one battery in the battery occurs off grid, plate softening, plate active material shedding phenomena such as short-circuit . At this point, the battery should be repaired in time to professional organizations to inspect, repair, or distribution group. This could be relatively extended battery life, maximize cost savings Inspiron 700m battery,Inspiron 710m battery.

Tips to avoid the three high-current discharge

Electric car start, manned, uphill, please help with the pedal as far as possible to avoid the momentary high-current discharge. High-current discharge easily lead to lead sulfate crystallization, to the detriment of the physical properties of the battery plates.

Charging time to master the right skills 4

The use of the process, should be based on the actual situation accurately charge time, refer to usual frequency of use and the mileage situation and pay attention to the capacity of the size of the battery manufacturers to provide instructions, as well as matching the performance of charger, the charge current to grasp the size of the charging parameters such as frequency of . General, batteries are charged at night, with an average charging time of 8 hours. If the shallow discharge (charge mileage is very short), the battery will soon be filled, to continue charging overcharge phenomenon occurs, leading to cell dehydration, fever, lower battery life. Therefore, the battery in order to discharge a depth of 60% -70% of the best to recharge a battery, the actual use can be converted into a riding mileage charge based on actual conditions necessary to avoid damaging charge.

5 tips to prevent exposure

Electric vehicles is prohibited under the sun exposure. Battery temperature is too high internal pressure makes the environment through increased cell pressure limiting valve was forced to automatically open a direct consequence of water loss is to increase the battery while the Inspiron E1405 battery cells will inevitably lead to excessive water loss decreased activity to accelerate the plate softening, charging shell body heat, since the shell drums, distortion and other fatal injuries.

6 tips to avoid the charging plug fever

Charger output plug loose contact surface oxidation phenomena such as charging plug will cause fever, fever for too long will lead to short-circuit charging plug, direct damage to chargers, lead to unnecessary losses. So, found out that the situation should be promptly removed oxides or replacement connector.

Comments are closed.